Posted by tom on January 08, 2012 at 11:00:46:
In Reply to: Profile shifting gears for a set shaft distance posted by Jim Pollock on January 02, 2012 at 08:40:33:
Normal Module (mm) 4.233
Centre Distance (mm) 128.000 (5.040)
Z29 Outside Diameter (mm) 130.37
Number of Teeth to measured 5 mm 57.23
z32 Outside Diameter (mm)142.51
Number of Teeth to measured 5 mm 57.34
with the data above are : backlash 0 !!!
z29 pinion -37%
z32 gear -67%
These measures should be, I do not assume any responsibility 'in case of errors ..
Post a Followup