Posted by MG on December 02, 2009 at 01:32:51:
In Reply to: Custom Gear Grinder? posted by Brian Payne on November 06, 2009 at 16:06:53:
Hello Brian?
What type of gear grinding are you looking for- spur / helical or bevel grinding?
I assume since you mentioned gearmotions and custom-gear you are referring to spur / helical grinding. However, the size of your part is especially important. Post OD, face width and pitch and I can give you some good leads.
Again, I assume you are looking for a supplier in the USA.