Re: Finish problem 6A Fellows shaper


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Sean on November 11, 2009 at 10:34:53:

In Reply to: Re: Finish problem 6A Fellows shaper posted by Bills on November 11, 2009 at 10:19:11:

The backing plate is the same size as the part root so I do not believe there is any flexing going on. There are small chunks taken out of tooth near the bottom half. The burr is very minamual. Could there be a problem with strokes per minute. Speed/feed. Iam very new to this so I thank you for bearing with me.
Thanks,
Sean


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]