Posted by MG on June 14, 2007 at 06:07:00:
In Reply to: Difference between Gleason & Klingelnberg posted by Alexis on May 17, 2007 at 06:29:45:
Hello Alexis, that is a rather loaded question you have there.
1. Firstly, is this your own company or are you working for a corporation? The economics vary greatly depending on the system of cutting but also WHERE you are located - in Europe or the USA because customer service becomes vital if you are a corporation.
2. Are you going to be manufacturing a wide range of crown wheel and pinions or a select small range? Number of setups is also important
3. Lastly, do you want to buy used or new equipment?
This is just a prelude to answering your questions. Write back either to the forum or directly and let's see what you have in mind.
Cheers!