Can this be hobbed?

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Greg on December 26, 2007 at 19:08:57:

Can the following be hobbed on a Barber Coleman 610?
I'm guessing that this is a worm but we've never cut a 22 start worm before. Any suggestions would be appreciated.

# Teeth 22
16 DP
14.5 PA
Pitch Diameter 4.840
Helix Angle 73 Deg 29 Min 43 Sec Left hand

Follow Ups:

Re: Can this be hobbed? Dan McEachern 20:52:13 01/10/08 (0)
Re: Can this be hobbed? Ron V 22:26:15 12/26/07 (0)

Post a Followup