Re: DP vs rpm


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Ron V on August 13, 2015 at 17:09:00:

In Reply to: DP vs rpm posted by jason o on August 11, 2015 at 17:22:55:

A very, very basic rule is that 'generally' you want to reduce the pitch in an effort to help reduce the length of the contact zone. This helps minimise heat generation at the point of meshing.
Reducing the pitch will also help in minimising the increase in vibration/noise as a result of the increasing rpm.



Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]