Re: Cutter number selection


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by MG on January 15, 2007 at 06:06:53:

In Reply to: Re: Cutter number selection posted by Ejenz on December 26, 2006 at 19:11:55:

#12-20 degree cutters are standard for roughing spiral bevel gears. They can also be used for finishing but that depends upon the ratio etc. Have you been using any calculation sheets? They should provide you with the information you require. You can email me with more questions if you would like - gearight@gmail.com


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]