Re: Internal toothed helical gear ball measure problem


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Carol on March 29, 2005 at 02:15:05:

In Reply to: Re: Internal toothed helical gear ball measure problem posted by Ron on March 28, 2005 at 19:08:14:

Hi Ron,

this is supposed to work as a helix drive and the mating gear is a long shaft with the same nr of teeth. So the centre distance is 0. Circular backlash is 0.1 mm and it is already incorporated in the tooth thickness. If the 5.5 mm balls are too big then 4.5 mm is fine, but would it be possible to calculate the measure for both of them?

Thanks very much.

Cheers, Carol


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]