Re: German? spline coupling


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Bill S. on October 29, 2000 at 13:33:01:

In Reply to: German? spline coupling posted by Kevin D on October 26, 2000 at 12:22:02:

This sounds similar to a harmonic drive, where the ratio of input/output shaft speed is (G2-G1)/G1 where G1 is the smaller and G2 is the larger number of teeth. Could your "splined" members be part of a high ratio speed reducer? If so, the inside 72T member would orbit around the eccentric input shaft without rotating, thus displacing the output member by 2 teeth on each orbit. This would produce a 36:1 speed reduction to an output shaft coupled to the 74T member.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]