Gear tolerence

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by RogerL on September 28, 2006 at 15:59:49:

I'm putting some end-gears on my lathe. The manual recommends a 003 gap between the two gears (meshing). Can someone give me an idea of what to use to measure this?

Thanks
Roger

Follow Ups:


Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]