Posted by Shahzad on September 04, 2006 at 14:54:36:
In Reply to: Re: Gleason No.11 Question posted by MG on September 01, 2006 at 06:53:53:
I do not use any rougher for the gear member. Only a standard cutter with soft body that have inside and outside blades is being used to cut the gear blank in single cycle. However tool did not allow to cut more gear, after it sharped once.If you have any idea for roughing the gear ( specification has been sent to you on your email address)Kindly inform me how can i maximize the gear production while using minimum inventory