Posted by Azher Shahzad on June 18, 2006 at 08:00:21:
Dear Sir,
I am producing a spur gear of the specification as below
Number of teeth =13
Module = 5.6444
Pressure Angle = 22° 30'
Pre shave Semi-Topping Cutter
Machine SYKES V10-B is being used for this purpose.
The profile error is required 0.04. BTL required 27.55 to 27.60. BTL is correct at machine but job gives much profile error than required.It is 0.08 to 0.1.
What is the reason for profile errors ? Is there any site with animation that shows full function of profile and profile errors?
How should I correct profile errors on machine ?
Give me some suggetions if anyone knows.
Thank you.