Posted by Bill S on August 14, 2003 at 08:30:30:
In Reply to: INDEX PLATE GRINDING? posted by Mark Schneberger on August 11, 2003 at 21:33:33:
Just a thought until someone gives us a good source - You might consider nickle and chrome plating if the wear is uniform and not excessive. You might be able to mask them by stacking and staggering teeth so only the notches and outside diameters are exposed.
I've never done this, but chroming is a typical wear rebuilding technique for crankshafts, spindles, etc. where wear is relatively small and uniform over the plateable area.