Re: hypoid


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by bostandoust on June 17, 2002 at 19:16:32:

In Reply to: Re: hypoid posted by Allan G on June 14, 2002 at 22:08:15:

Thank you for your response.
I have the gear blank dimension and cutter as well.
Basic settings are general setting among the gleason machine generators.Based on this concept,there are some formulas to obtain the machine settings,for example if you have the settings for Machine 116 you can obtain the basic settings and then you can obtain the settings for the other machines like machine 16.
Due to this I need formulas between basic settings and machine No. 16.
For further information you can see the following books and papers:
1-F.L.Litvin,Y.Zhang,et al.Determination of settings of a tilted head cutter for generation of hypoid and spiral bevel gears,ASME J.Mech.,Transm.Automation Des.110(1988)495-500
2-F.L.Litvin, C.Kuan,et al.,Minimization of deviations of gear real tooth surfaces determined by coordinate measurements,ASME J. Mech. Des. 115 (1993) 995-1001
3-F.L.Litvin 1994,Gear Geometry and applied Theory,Prentice Hall.page Number 630.
I look forward to hear from you.



Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]