Re: CPC-24 Question


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Josh on June 22, 2012 at 17:03:43:

In Reply to: CPC-24 Question posted by BillS on June 21, 2012 at 19:53:16:

Bill,
I can't answer the question directly but, I believe
the tooth angles will be different for 14.5 and 20
PA and that difference would produce the wacked out
tooth measurements. This would be true if the software
didn't change the tooth angle when 20 PA
was input within the "Old 14.5 system"
Did your customer get a good heel measure at the
outputted tooth angle? Maybe I should just go back
outside and paint the house some more.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]