Re: Gleason 16p


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Don P. on April 18, 2012 at 18:21:03:

In Reply to: Re: Gleason 16p posted by mike on April 02, 2012 at 13:41:27:

Regarding your question about finishing in the R16, yes it can be done without any real problems, other than having blades that have the correct pressure angle , that is , the same number as calculated.

Without tilt and swivel angles , you would end up making rather large headsetting (cone distance changes) and eccentric angle corrections.

The feed cam on fhe R16 has a 2 path cam, rough and finish. The decimal ratio is the same for R16p, 26 gen and 16 hypoid generators. I'll send formula in the morning as I'm not at my office now.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]