Re: 6T Spline


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Russ on May 03, 2012 at 22:29:31:

In Reply to: Re: 6T Spline posted by Ron V on May 03, 2012 at 22:04:35:

Flank flat on active part of the profile. Don't have exact measurements on-hand...they are at the shop. As close as I can remember, hob designed to cut .302" but actually cutting around .264". I will double check my figures tomorrow at the shop. i sure appreciate your input thus far Ron V.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]