Re: Barber Colman 2 1/2-4


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by BillS on March 09, 2012 at 17:29:09:

In Reply to: Barber Colman 2 1/2-4 posted by David Hollinger on March 08, 2012 at 13:56:46:

Are you climb cutting? That would be table feed in a direction that allows the cutter to "pull" itself into the workpiece. Climb cutting is usually toward the tailstock, but I'm not familiar with a 2 1/2-4 hobber.

The "push back" part doesn't seem to fit a climb cutting situation...


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]