Re: gear shaper MAXICUT operating manual


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Mike on January 20, 2012 at 03:25:45:

In Reply to: Re: gear shaper MAXICUT operating manual posted by inshaajee on January 19, 2012 at 08:20:10:

Hi
If the machine is a 2 series machine(either 2a/2c)Indexing spur gear formula is as follows:

(A) Number of teeth in job               (C)  60
----------------------------     X     --------
(B) Number of teeth in cutter            (D)  60

This is the same as a fellowes 7 series machine.
There is no formula for cutting helicals on these machines.Helicals are cut with the use of cutter guides and special form cutter.A very expensive way of cutting helicals


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]