Posted by Josh on November 16, 2011 at 14:35:46:
In Reply to: Re: fellows 8 AGS gear shaper posted by Ron V on November 16, 2011 at 14:12:26:
Ron, Thanks....First thing I did was look at the
hob rack....no 20/40....I have done that before.
I wonder if I could use the shank shaper to cut
the male? The ratio would be the same... only have
to add the idler for the internal....Just got off
the phone...they are sending the whole d*** motor.
So I may have to make a plug because the motor's
Post a Followup