Posted by Jim Pollock on October 29, 2011 at 23:03:03:

In an old post, Tom Ramsey had given a formula for calculating the amount of final cut when hobbing.

I believe it was measurement over wires - required measurement over wires divided by two and multiplied by 1.37. This was for 20 degree pressure angle.

What would it be for 14 1/2, 25 and 30 degree
pressure angle?

- Re: Question for Tom Ramsey about calculating final cut
**tom***08:21:19 10/30/11*(3)- Re: Question for Tom Ramsey about calculating final cut
**BillS***11:56:29 11/02/11*(2)- Re: Question for Tom Ramsey about calculating final cut
**Tom Ramsey***18:57:21 11/10/11*(1)- Re: Question for Tom Ramsey about calculating final cut
**Jim Pollock***17:52:52 11/11/11*(0)

- Re: Question for Tom Ramsey about calculating final cut

- Re: Question for Tom Ramsey about calculating final cut

- Re: Question for Tom Ramsey about calculating final cut