Posted by Jim Pollock on November 15, 2009 at 08:54:08:
In Reply to: Re: Topping hob question posted by Ron V on November 15, 2009 at 01:30:44:
Thanks again for the reply. I am pretty new to cutting gears so I apologize for any dumb questions.
I will be making both mating gears for this transmission. I was under the assumsion that 2.157/dp was the normal depth. I know that ash gear lists it as being normal depth. Is the industry going to the deeper teeth? Will using this hob cause the gears to make more noise?
Post a Followup