Re: hob arbors for Barber Colman


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Bob M on September 25, 2008 at 00:44:01:

In Reply to: Re: hob arbors for Barber Colam posted by Drew on September 24, 2008 at 16:07:51:

I contacted Ash. They don't have tooling for Barber Colmans. I also contacted Bourne Koch. They're going to quote me some tooling. It's not a Morse Taper. The taper angle is 8.5 degrees. I'd think someone out there has a whole bunch of used hob holders for Barber Colmans. I'll keep looking.




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]