Re: pin measurements


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Alan on May 07, 2007 at 19:56:30:

In Reply to: pin measurements posted by steve green on May 07, 2007 at 06:01:11:

Short answer is no. BUT, depending on the tolerance, you are probably safe to do so. Lets say your pin size is 3.105"/3.095" over .188 pins, you would be fine using .189 & .187 pins as long as you tighten you tolerance slightly to 3.103"/3.097" (just to be safe).


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]