Re: spiral bevel splines


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Ken on March 28, 2007 at 18:26:28:

In Reply to: spiral bevel splines posted by jason olson on February 15, 2007 at 03:28:20:

Due to the critical contact requirements of a spiral. You need to have the gear held concentric. I would suggest a tight parallel spline, with a gear minor dia. fit. If an involute is used, a major dia. fit 30 degree, depending on the size of spiral and the loads you have.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]