Posted by Samir Shah on March 15, 2007 at 04:34:41:
In Reply to: Blank offset in machine summary posted by Samir Shah on March 05, 2007 at 12:33:07:
In Hypoid gear generator specification, under the title of "work head settings" values of maximum offset abover centre and below centre is shown. For example, for gleason no. 118 hypoid generator, the value of maximum offset above and below centre is 114.3 mm ( 4.5").
If the machine has a provision of work offset above and below centre than we can cut hypoid gear as well as spiral bevel gear (keeping the zero offset) on that.
If the spiral bevel machine doesn't have any provision of offset then we can not cut hypoid gear on that. am i right? Please correct me if i have misunderstood.
Post a Followup