Re: off-angle bevel gear design


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Brian Dengel on December 11, 2000 at 16:37:57:

In Reply to: Re: off-angle bevel gear design posted by jlfork on December 07, 2000 at 03:30:41:

The recommend face width is limited to the smaller value of either 10 times the module or 1/3 of the cone distance (Re). Since Re is a function of the pitch diameter and the pitch angle, as you change the pitch angle, you limit size of the face width.
This is a function of the cutter not of the geometry.



Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]