Posted by RonV on February 25, 2007 at 15:20:59:
In Reply to: Coventional Universal Toolmiling Mashine posted by Andreas on February 24, 2007 at 06:36:08:
Here are some links to help you get started:
You'll be able to reverse engineer the gear using these two online
calculators for help.
You'll need to download and install this program to help you work out the
change gears required to reproduce the helix angle from a decimal ratio,
calculated using the mill's leadscrew lead and the dividing head's ratio.
(If you've already been cutting gears for a while then I'm assuming you
already know how to do this)
Post a Followup