Hobbatical


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by JamesD on August 04, 2007 at 04:12:44:

Reverse eng. a shaft, I cut 8/16 dp 22t on G & E 24h.
These teeth mesh with another internal gear for a clutch assembly. Actually like a multiple spline. Apparently a
chamfering hob was used . Doh! Any ideas on best fix?
This chamfer is only issue.





Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]