Posted by Shahzad on October 18, 2006 at 18:11:27:
I heard about some method of Gleason system.It is Five cut method,and special jobbing method.
How these mathods work ?
Normally pinion memebr is proiduced with using fixed setting method where an inside and outside cutter blade is require for finishing pinions and three machines are required for complete operation of pinion memeber.Thus two machines are required for gear member.This increase the tooling and spares inventory of machines and are very costly.
Which mehthod is prefferable can be use with minimum tooling & machinery inventory and obviously should be cost effective.
Post a Followup