Re: Right Hobber?


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by mkk on May 25, 2006 at 01:19:39:

In Reply to: Re: Right Hobber? posted by BillS on May 23, 2006 at 16:08:10:

I was thinking of the Barber Coleman #3 as well. I think I would try to run the part on a slower feed and take it in one pass. I am not too sure due to the material hardness. The other problem is 16 pitch and hard material on the Barber Coleman #3 could pose a problem due to the depth of cut.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]