Re: Right Hobber?


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by mkk on May 22, 2006 at 22:11:35:

In Reply to: Right Hobber? posted by mark schneberger on May 21, 2006 at 16:55:10:

What is the material? What is the face width of the gear? Is the face of the gear 5" long or is the shaft 5" long with a smaller gear section on it? How may pieces on your order? What is your current hobbing time per piece? What is your feed and cutter RPM? How are you holding the work piece? I assume there is a center in at least one end if not both.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]