Re: about shrink disc


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by BillS on January 26, 2006 at 21:26:13:

In Reply to: about shrink disc posted by ravi on January 25, 2006 at 18:46:46:

I found a website offering this type of keyless connector:
www.b-loc.com/shrinkdiscs.htm
I think that direct shaft to shaft coupling using a shrink disc as a coupling would not be too good, since alignment would be critically important. But there are sleeves for shaft to shaft that use two shrink discs (shown in one of their illustrations). Normally shaft to shaft is done though a form of flexible coulpling to allow for a degree of misalignment.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]