Posted by MG on January 09, 2006 at 12:03:39:
1. I have a 1.27 module (20 DP) spiral bevel job on hand and am mulling over production methods, Duplex Helical being my first choice. What are the other methods that anyone would recommend and any benefits or disadvantages that come along with them?
2. Could anyone please clarify what "#c - actual cutter number" is? Is there a seperate list of cutter numbers that might have been left out of the calculation manual or is that always a seperate phamplet?
3. If a calculation yields a value in minutes, does converting that value to decimal degrees alter the setting summary outcome?
Thank in advance.
Post a Followup