Re: spiral bevel gear inverted spiral


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Stepan Lunin on December 07, 2005 at 22:44:21:

In Reply to: spiral bevel gear inverted spiral posted by MD on September 14, 2005 at 12:28:26:

It should be not a problem to set up a machine to do it. The major difference would be in cradle angles. The problem may be with the narrowing of the topland on the toe.
I do not know if Gleason software has capability to simulate the cutting. But with Direct Digital Simulation method it is not a problem.

Stepan Lunin

www.zakgear.com



Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]