Re: Index and feed problem


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Charley Briggs on March 23, 2005 at 08:28:07:

In Reply to: Re: Index and feed problem posted by Bill S on March 22, 2005 at 15:35:49:

Bill,
we replaced the gears,NO luck the blank is still being milled off, we tried to set the hob with 16deg. 7min. clockwise No luck then out of frustration we tried c'clockwise NO luck, any ideas? thank-you Charley -- Where are you located geographically ? we are in No.western Massachusetts.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]