Re: Bull gear alignment


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by MIKE POTERE on March 11, 2005 at 22:15:58:

In Reply to: Bull gear alignment posted by Joel Thompson on March 11, 2005 at 10:43:52:

JOEL, THIS MAY NOT HELP YOU OR YOU MAY EVEN ALREADY KNOW THIS BUT HERE GOES:
MAKE SURE BOTH PARTS ARE CLEAN.
PAINT THE WORM THREADS WITH INDICATING FLUID.
GIVE THE WORM A FEW TURNS AND NOTE WHERE THE INDICATING FLUID HAS MARKED THE WORM GEAR (BULL GEAR) TEETH. SHIM THE WORM GEAR & KEEP REPEATING THE PROCESS UNTIL THE INDICATING FLUID MARKS THE WORM GEAR EVEN OVER THE THE FACE OF THE WORM GEAR.
HOPE THIS IS WHAT YOU WERE ASKING.
MIKE


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]