Re: Cutting Spur Gears with a Shaper


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Josh Ward on December 12, 2003 at 07:56:05:

In Reply to: Cutting Spur Gears with a Shaper posted by Mike on July 04, 2003 at 15:57:54:

I tried this method once before I had a hobber.I used a table shaper and a dividing head sincronized to the table feed screw. Had to make up a plate to mount the change gears and a shaft had to be made to slide through the last change gear as the table advanced through the cutting mesh. The blank had to be roughed out first and then generated . It was a 3/4 stub 20 deg PA 17 teeth .


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]