gear standard


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by mike on December 02, 2002 at 05:27:02:

hi,
someone can help me?
i'm looking some information about "AMERICAN STANDARD 14 1/2 degree composite system".

is it possible that this standard is the same as ANSI B6.1 and AGMA 201.02???

i need pin diameter and measure over pins for 12/24 spline, 14 1/2 degree, 64 teeth and no offset.
thank you very much


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]